![]() ![]() ![]() I don’t know which wire can lead to the dump valve wich unlock the other valve, and I don’t know where is the pressure sensor. On the orbitrol, I have a 4 pin plug, on wich there is 5200 wire (12v I think), ground, 35. Yes I looked at the other compartment on the ECU, but there isn’t the good amount of wires, and only 2 wires give the informations (2 CAN wires : 390 and 391). On the user manual, that’s written that the relay is for autoguidance stop valve. For continuous variables (speed, SoC, RPM. The problem isn’t to know which relay is for wich solenoid, but to know why there is only one remaining instead of 2. In the wiper case, the signal may be a boolean (on/off) - and you may simply set the offset to 0 and scale to 1. (In cab, this wire number isn’t powered). I find the good wire on the WAS (2177) ( 1V at the right, 2.5 at the middle (and probably 4 at the left)).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |